https://juci.iopsys.eu/v4.2.x/en/ 2026-04-06T04:31:15+0200 https://juci.iopsys.eu/v4.2.x/en/ https://juci.iopsys.eu/v4.2.x/en/lib/tpl/inteno/images/favicon.ico text/html 2019-03-02T21:27:11+0200 Anonymous (anonymous@undisclosed.example.com) https://juci.iopsys.eu/v4.2.x/en/usb/network/multiwan/feature/mw_members?rev=1551558431&do=diff Members is a way to define multiple ways to prioritize the Interfaces that Multiwan is using. The prioritizing is done using Metric and Weight. The Member within one policy with a lower metric have precedence over higher metric members. Members within one policy with the same metric will distribute load based on this weight value (Example weight 1 and 4 will balance the traffic so the first interface gets 20% of traffic and the second gets 80%. text/html 2019-03-02T21:27:11+0200 Anonymous (anonymous@undisclosed.example.com) https://juci.iopsys.eu/v4.2.x/en/usb/network/multiwan/feature/mw_policies?rev=1551558431&do=diff Policies is just a way to hold 1 or more members. It is NOT possible to add multiple members from the same interface if they have the same metric (if the metric are different it doesn’t make sense to add multiple members from the same interface because the one with the lowest will always be used but its allowed). text/html 2019-03-02T21:27:11+0200 Anonymous (anonymous@undisclosed.example.com) https://juci.iopsys.eu/v4.2.x/en/usb/network/multiwan/feature/mw_rules?rev=1551558431&do=diff Rules are the way the Policies are applied to the traffic. Each Rule targets packets with some kind of filter. The Rules are applied in order from top to bottom, this means that there can be multiple rules that is using same or different policy that targets different traffic. text/html 2019-03-02T21:27:11+0200 Anonymous (anonymous@undisclosed.example.com) https://juci.iopsys.eu/v4.2.x/en/usb/network/multiwan/feature/start?rev=1551558431&do=diff The MultiWAN Feature Sample Configurations text/html 2019-03-02T21:27:11+0200 Anonymous (anonymous@undisclosed.example.com) https://juci.iopsys.eu/v4.2.x/en/usb/network/multiwan/feature/workflow?rev=1551558431&do=diff * Create all the interface sections needed each corresponding to one of the network interfaces that should be tracked by Multiwan. Make sure that the Host(s) to ping are reachable from the interface when the interface is working correctly and that the interface is Enabled! All network interfaces used in Multiwan must work by them self and all of them need to have a default route, this is only possible if the interfaces have different metric set in the network configuration.